How do you program a hunter sprinkler controller?

VIDEOClick to see full answer. Also know, how do you program a hunter sprinkler system? X-Core – Programming Start Times Turn the dial to the START TIMES position. The factory preset is set on program A. If necessary, you can select program b, or C by pressing the PRG button. Use the plus (+) or minus (-) button to change the start time. Press the arrow (>) button to add an additional start time, or PRG button for the next program. how do you reset a sprinkler system? How to Reset a Sprinkler System Turn the control dial to the “off” position. Press the “next” button to access the clear-memory feature. Press and hold the “off” button until the display stops blinking. Turn the control dial to the “run” position. Press and hold down the “minus” arrow and “prog” buttons simultaneously. Similarly, you may ask, how do you manually run a hunter sprinkler system? X-Core – Manually Run a Single Station Turn dial to MANUAL – ONE STATION position. Station run time will flash in the display. Turn the dial clockwise to the RUN position to run the station (only the designated station will water, then the controller will return to automatic mode with no change to the previously set program). How do I reset my Hunter irrigation system?Resetting a Hunter X-Core is easy. To reset the irrigation controller, all you need to do is press the negative, the hand and the program keys at the same time, then use a small tool to press in the small reset button on the side of your controller. A small screwdriver or a pen will do the trick.